How to Flash Mi Mobiles in EDL Mode
Flashing a Xiaomi (Mi) phone in Emergency Download (EDL) mode is typically done when you need to unbrick, restore, or upgrade the firmware on your device.
Here are the general steps to flash a Mi phone in EDL mode:
Important Note: Flashing your phone in EDL mode can be risky and may void your warranty. Make sure you have a backup of your data and understand the risks involved before proceeding.
Prerequisites:
Download Necessary Files:
Xiaomi Mi Flash Tool: Download the latest version of the Mi Flash Tool from the official Xiaomi website.
Fastboot ROM: Download the appropriate Fastboot ROM for your Xiaomi device from the official Xiaomi website.
Install Drivers: Install Qualcomm USB Drivers on your computer if they are not already installed.
Charge Your Phone: Ensure your phone has enough battery to prevent it from shutting down during the flashing process.
Steps to Flash Xiaomi Phones in EDL Mode:
Enable Developer Options and USB Debugging: Go to Settings > About Phone. Tap on the "MIUI Version" or "Build Number" multiple times until you see a message that says "You are now a developer!"
Go to Settings > Additional Settings > Developer Options and enable "USB Debugging."
Power Off Your Phone: Turn off your Xiaomi phone completely.
Boot into EDL Mode: EDL mode method can vary between Xiaomi devices.
Common method: Connect your phone to your computer via a USB cable. Hold down the "Volume Down" and "Power" buttons simultaneously for about 10 seconds. Your phone should enter EDL mode, and the screen will remain blank.
Method 2nd. Open back penal of your mobile and remove battery. Find the Test Point Of Your device And connect them with help of a tweezer. Now insert Data cable into your mobile and connect battery.
Example: Redmi 4x Test Point For EDL Mode
Install Mi Flash Tool: Install the Mi Flash Tool on your computer if you haven't already.
Launch Mi Flash Tool: Open the Mi Flash Tool on your computer. Select Flashing Method: In the Mi Flash Tool, select the "Browse" button and locate the Fastboot ROM you downloaded earlier.
Connect Your Phone: In the Mi Flash Tool, click on "Refresh" to detect your phone. It should show up with a COM port number.
Choose Flashing Mode: Select "Clean All" or "Clean All and Lock" depending on your preference. "Clean All" will erase all data, while "Clean All and Lock" will also relock the bootloader.
Start Flashing: Click the "Flash" button in the Mi Flash Tool to start the flashing process. Wait for Completion: The flashing process may take a few minutes. Do not disconnect your phone during this time.
Completion and Reboot: Once the flashing is complete, the Mi Flash Tool will display "The operation completed successfully." You can now disconnect your phone.
First Boot: Boot your phone by holding down the Power button. The first boot may take longer than usual.
It's Done! Enjoy👍
0 Comments